Comparison ledger
Laurell H6-23, Laurell WS-650-23, side by side. Every value shown is drawn from the cited encyclopedia entries.
| Attribute | H6-23Laurell | WS-650-23Laurell |
|---|---|---|
| OEM | Laurell | Laurell |
| Category | Spin coater | Spin coater |
| Wafer size | 150mm | 150mm |
| Process node | — | — |
| Introduced | — | — |
| Production run | — | — |
| Lifecycle | — | — |
| Lifecycle milestones | — | — |
| Control system | — | — |
| Generation | 650-series HL | — |
| Family | Laurell H6-23 | Laurell WS-650-23 |
| Cited variants | — | |
| Specifications | ||
| Maximum rotational speed | 12,000 RPM (based on a ø 100mm silicon wafer)[3] | 12,000 RPM (based on a ø 100 mm silicon wafer)[1] |
| Wafer capacity | Up to ø 150mm wafers[3] | Up to ø 150 mm wafers[1] |
| Substrate capacity | 5" × 5" (127mm × 127mm) substrates[3] | 5" × 5" (127 mm × 127 mm) substrates[1] |
| Power | 95 to 240VAC, 47/63HZ, ~300 Watts[3] | 95 to 240VAC, 47/63HZ, ~300 Watts[1] |
| Category | Spin coater[3] | — |
| Wafer size | Up to 150 mm wafers[3] | — |
| Substrate size | 5 in x 5 in (127 mm x 127 mm) substrates[3] | — |
| Speed basis | Based on a 100 mm silicon wafer[3] | — |
| Series | 650-series HL coater system[3] | — |
| Model | — | WS-650-23 B Spin Coater[1] |
| Mounting | — | Station Mounted[1] |
| Required N2 process/seal purge | — | 60–70 PSIG (4–5 bar) of Nitrogen/CDA[1] |
| Vacuum | — | 25–28 inches Hg; suggested flow volume 4.5 SCFM (0.127 cubic meters/minute) at 0 inches Hg[1] |
| Processes supported | — | Coating, Etching, Developing, Rinsing-Drying and Cleaning[1] |
| Maximum substrate size | — | 150 mm wafers, 5" × 5" (127 mm × 127 mm) substrates[1] |
| Vacuum requirement | — | 25–28 inches Hg (~635–711 mm Hg) with a flow volume of 4.5 SCFM (0.127 m³/min) at 0 inches Hg[1] |
| Seal/process purge gas | — | N₂ at 60–70 PSIG (4–5 bar)[1] |
| Gas consumption (standard motor) | — | 3 cubic feet per hour (0.085 m³/hour)[1] |
| Gas consumption (high-performance motor) | — | 20 cubic feet per hour (0.566 m³/hour)[1] |
Plan your fab
Building a Spin coater process? Get a complete equipment list.
Open the fab equipment planner →