Comparison ledger
Laurell EDC-HL-15, Laurell EDC-HL-23, side by side. Every value shown is drawn from the cited encyclopedia entries.
| Attribute | EDC-HL-15Laurell | EDC-HL-23Laurell |
|---|---|---|
| OEM | Laurell | Laurell |
| Category | Spin coater | Spin coater |
| Wafer size | 300mm | 150mm |
| Process node | — | — |
| Introduced | — | — |
| Production run | — | — |
| Lifecycle | — | — |
| Lifecycle milestones | — | — |
| Control system | — | — |
| Generation | 650-series | 650-series |
| Family | Laurell EDC-HL-15 | Laurell EDC-HL-23 |
| Cited variants |
| |
| Specifications | ||
| Model | EDC-HL-15 B[1] | — |
| Series | 650-series EDC system[1] | — |
| Wafer/substrate capacity | Up to ø 300 mm wafers and 9" × 9" (229 mm × 229 mm) substrates[1] | — |
| Maximum speed capability | 12,000 RPM with vacuum hold-down[1] | — |
| Recommended speed | 3,000 RPM[1] | — |
| Recommended chuck type | Non-vacuum chucks[1] | — |
| Power | 95 to 240 VAC, 47/63 Hz, ~300 Watts[1] | 95 to 240 VAC, 47/63 Hz, ~300 Watts[2] |
| Category | Spin coater[1] | — |
| Wafer capacity | Up to 300mm wafers[1] | Up to 150 mm wafers[2] |
| Substrate capacity | 9 in × 9 in (229mm × 229mm) substrates[1] | Up to 5 in x 5 in (127 mm x 127 mm) substrates[2] |
| Process controller | — | 650-series process controller[2] |
| Maximum rotation capability | — | 12,000 RPM with vacuum hold-down[2] |
| Recommended operating speed | — | 3,000 RPM with non-vacuum chucks[2] |
| Nitrogen/CDA seal purge pressure | — | 60–70 PSIG (4–5 bar)[2] |
| Vacuum recommendation | — | 25–28 inches Hg with 4.5 SCFM at 0 inches Hg[2] |
Plan your fab
Building a Spin coater process? Get a complete equipment list.
Open the fab equipment planner →